Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - kg7bz

Pages: [1]
1
Success!! Thanks very much!

August KG7BZ

2
I am completely unable to get CAT info to connect from the radio to the control end. I can take my laptop to the radio and hook the CAT serial cable to the laptop serial port and it works fine. If I connect the Radio CAT cable to port COM2 on the Radio RRC and connect the laptop serial cable to COM 1 OR COM 2 on the Control RRC, nothing. I DO have the baud rate set to the correct number on both ends. Both the Radio and Control RRC have COM1 set to mode 7.

And yes, I am using a CAT cable powered by the radio, not the serial port.

August KG7BZ

3
Here's the situation I have. FT-857D has antenna tuner attached to CAT/Tuner port so I don't have CAT port available. I want to run Ham Radio Deluxe on the control end.

I see in the manual that the Serial setting for COM2 shows "Logical parallel with COM0. = Is used for level converting for CI-V and FT-8x7."

Does this mean that it will extract and bring CAT data to the serial port at the control end to hook to my computer? If so, will this work with using the USB port for serial connection on the control end? I've tried this and can't get HRD or another logging program to connect to the radio. I just get a stream of 0909090909 received from the radio.

Is this supposed to work this way or am I out of luck using my tuner and also HRD?

Thanks,

August KG7BZ


Pages: [1]