1
Configuration, RRC 1258 / Re: Twin K3/0, N1MM+ correct settings
« on: 2019-01-07, 06:49:54 »
Mitch, done! It works now. Many thanks for your support and warm wishes to FL. 73, Sergei UA3AP (aka K3AO)
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Configuration, RRC 1258 / Twin K3/0, N1MM+ correct settings
« on: 2019-01-06, 18:02:38 »
Folks, was away from the remoterig stuff for 7+ years. Now is back and wish to reactivate it. Have old RRC1258MKII purchased I believe in 2012 or 2011. K3/0 unit (S/N18) and using the N1MM+
Facing the following issue - N1MM+ reads K/0 unit, but can't switch it to TX CW (no keying at all). Settings - COM1 mode - mode 7, USB COM1 port yes, COM2 mode logical parallel with COM0, Use USB COm2 port - No.
In N1MM+ for CW DTR is always on, RTS is always off.
What I'm doing wrong? Thanks, 73 Sergei UA3AP
Facing the following issue - N1MM+ reads K/0 unit, but can't switch it to TX CW (no keying at all). Settings - COM1 mode - mode 7, USB COM1 port yes, COM2 mode logical parallel with COM0, Use USB COm2 port - No.
In N1MM+ for CW DTR is always on, RTS is always off.
What I'm doing wrong? Thanks, 73 Sergei UA3AP
3
General discussion forum / Turning "ON" remote K3
« on: 2010-08-25, 07:18:38 »
Hello, a question to K3 users. How do you solve the issue with the turning ON the K3 at remote end? As far as I know the ACC connector has an assigned pin which should be momentary shorted to ground in order to switch radio ON. Can I use the I/O settings for that? Thanks, 73 de Sergei UA3AP
4
General discussion forum / Manage remote antennas
« on: 2010-07-12, 12:18:26 »
I'm thinking to try the RRC set. The question I have is what is the solution on on remote antenna switching? I have DX Engineering antennas on remote site (4SQ RX) plus separate vertical. Thanks, 73 de Sergei UA3AP
Pages: [1]