Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - sq5bls

Pages: [1]
1
Configuration, RRC 1258 / High UDP SIP Frame ratio
« on: 2021-03-21, 16:32:27 »
Hi,
does anyone know how to decrease frame rate of SIP connection? Regardless of settings it is still about 100 frames /second, which causes problems in my network. For second radio I'm using other solution, from polish company with software radio panel and there frame rate is about 50/sec and do not causes problems in network. I've tried different settings of buffers size etc, but it haven't change the very fast frame rate. I'm using RRC with 2.95 software version. Please help !

2
Hi, I'm using FT8900 with new RRC, 2.95 firmware. The problem is, that when there is no receiving signal, radio part is still sending UDP frames with audio. I tried all 3 settings in Advanced menu, "RTP tx mode" - Squelch, Normal and Continuos. In LAN network it is not a problem, but when I use Internet connection it couses unwanted traffic. I thing that RRC do not recognise when the radio is squelched or not. My second question is, if I can use RRC setup with non listed type of radio, i.e. motorola using rx, tx audio signals and ptt and COR (busy) signal ?
Regards
Maciek
SQ5BLS

Pages: [1]