Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - UX0LL

Pages: [1]
1
Finally the problem was solved.

I've replaced Ethernet controller on the pcb board of RRC unit.

Works fine again!

Alexander UX0LL

2
Thanks Mitch!
I've connected via USB and activated DHCP on the Box.

This is Net info. seems that Ethernet adapter on RRC is failed.

MAC       : 00:50:c2:11:91:f2
IP address: 0.0.0.0
Netmask   : 0.0.0.0
Gateway   : 0.0.0.0
DNS       : 192.168.0.1

Alexander UX0LL

3
Mitch,

Tryed few times without results. Can I connect via telnet to check Ethernet port live or dead?

4
Thanks Mitch!

How to perform full Hardware Reset?

Alexander UX0LL

5
Right, when cable unplugged.

Is there any options to check it - HW or SW bug? If HW - what component to replace?

Alexander UX0LL

6
Strange that Ethernet port Green LED is always ON.
Seems that port is not workin properly.

7
Hi Mitch,

Thanks for your reply!

Actually I've checked IP settings as well. There are some investigation pasted:
Net Info from Control RRC

MAC       : 00:50:c2:11:91:8f
IP address: 192.168.1.227
Netmask   : 255.255.255.0
Gateway   : 192.168.1.1
DNS       : 192.168.1.1

Net Info from Radio RRC:

MAC       : 00:50:c2:11:91:f2
IP address: 192.168.1.228
Netmask   : 255.255.255.0
Gateway   : 192.168.1.1
DNS       : 192.168.0.1

I see that DNS on Radio RRC changed somehow to 192.168.0.1 instead of 192.168.1.1

Alexander UX0LL


8
Hi dear Colleagues!
Will be appreciated for any advice how to fix this problem:
My remote Radio RRC works great during 7 mothns without any issues at all.
Last week I've lost the connection to this box. Site survey shown that the issue is with RRC.No connection via Web interface and every 20sec or so rebooting. USB is workin but unable to try firmware rewnewal due to rebooting process. Than Set default settings procedure via USB using Setup Manager v1.10 helps to upload new firmware v.2.41 to the RRC. But Web interface is still unaccessible. Green LED on Ethernet port is alwayz ON even without LAN cable connected.

Seems that problem happen with web interface inside RRC. Is there any experience how to fix this issue?
Thanks!

Alexander UX0LL

Pages: [1]