Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - 4Z4OQ

Pages: [1] 2 3 ... 7
1
General discussion forum / Power drop in FT8 Hound mode
« on: 2020-02-05, 16:28:58 »
Hi

After some tweaks I am working standard FT8 with my TS480 w/o any issues. However, orking in F/H mode as Hound when the fax stations are RX on low audio freq, an my TX jumping to the low audio freq (~270hz) my output is attenuate (power signal drops ).

I made a test with another ham located 1 mile from my remote TX and my signal is +7DB (1200HZ audio) and drops down to -12 in 300HZ audion.

Is the RRC got a audio bandwidth limitation/filter in low audio freq?

thanks
Ziv

2
General / Re: App Period expired
« on: 2019-01-02, 19:05:33 »
HNY. can i pls get a reply ?

3
General / App Period expired
« on: 2018-12-09, 14:54:54 »
Hi


I got App Period expired but never had a chance to use it on my S8 phone. how can i try it and how can i buy it

thanks

Ziv
4Z4OQ

4
General discussion forum / Re: IC-2730 with RRC??
« on: 2016-12-16, 06:48:21 »
Mike???

5
General discussion forum / Re: IC-2730 with RRC??
« on: 2016-12-13, 18:40:26 »
Anyone??

6
General discussion forum / IC-2730 with RRC??
« on: 2016-12-12, 18:20:55 »
Hi
Would RRC support Icom VHF  IC-2730?

Thanks
Ziv

8
General discussion forum / Re: RF killing RR box at Remote.
« on: 2015-11-28, 09:53:51 »
Hi Frank

i had & have same problem. 80-60-40-30m bands. I could not TX more then 50-60w. What i did is adding snap ferrites on all the power lines that are 220v and 13.8V / Lan cables / cat232 cables. Now i can TX 500W on 80-40-30 without any problem.

TX on 60meters still "kills" my router connection but i think it is due to high SWR because i am loading via the KPA500 tuner the the 40meter dipole for 60m.
I will add a new dedicated dipole for this band and hope to solve this issue as well.

Good Luck
Ziv- 4Z4OQ

9
Hi

I was suffering from the same issue. I found that in most cases it was due to a very short electricity off/of at my radio location. Only reset (power off for 2-3sec) would help. Added small UPS and ok for 6 months

Ziv

10
General discussion forum / band sniffing via CAT com
« on: 2015-05-31, 15:29:35 »
Hi
I would like to build and band sniffing to my ts-480 with arduino software using a Y cable to the CAT com in order to control an ant switch. As I am building this on the remote site my question how can I stimulate this without traveling to the radio side.

Will the comport of the cat in the remote is same as at radio?

Thanka Ziv

11
General discussion forum / Moxa Nport W2150A for sale
« on: 2015-05-10, 13:17:18 »
Hi

Before advertising on eBay, I got NIB never used MOXA W2150 (lan/Wifi) 232 server (1 port)    Asking 150 EU - shipping included

Ziv

12
General discussion forum / Re: TS-480 Voice Keyer Question
« on: 2015-04-06, 10:58:17 »
Hi John

do you have a PC connected to the RRC for digital mods? i have several recordings and  with different macros I send them as voice keyer

Ziv

13
General discussion forum / Re: On/Off TS-480 head
« on: 2015-03-24, 13:27:44 »
Hi Mike

some time when i am a work i can log to my home computer via teamviewer and lsn to cw stations but need to power-up the 480 head

Ziv

14
General discussion forum / On/Off TS-480 head
« on: 2015-03-24, 12:59:50 »
Hi

Is it possible to turn ts-480 remote head on from via rrc ?

thanks
Ziv

15
General discussion forum / Re: Lost of web server port
« on: 2015-01-09, 08:31:02 »
HI

Due to the above what can be my next step? I Can get someone with a computer at the Radio side and connect with setup manager. would i be able to see radio RRC without knowing the webserver port?

Pages: [1] 2 3 ... 7