Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - WX1CT

Pages: [1]
1
I have spent the last few days trying to setup the remoterig with my TS-480AT. Everything seems to work fine on my internal LAN. I had the radio on for about 20 minutes earlier today with no problems and great audio! My problem (like most I assume) is when I try to use the remote rig Control from another location. I have been trying from my work qth and as you will see from the notes below once I connect by turning on the control head power, the RTP/[UDP numbers start dropping until the connection drops and the remote head goes off. Then I need to reboot the RRC-Control unit to attempt a reconnection. Any suggestions or guidance is appreciated. I won't be here at work again until Wednesday so if you send a suggestion it will be a few days before I can test it out.

73 Phil
WX1CT

----------------------------

Status
Name   Value
Radio   ON
Connection status   Faulty(See below)
SIP status   Connected/transfering
Last SIP error   None
RTP/UDP audio status   Stalled(45)
UDP cmd status   OK(30)
SIP command timeout   0
Rx Jitter buffer size   16
Rx Jitter delay   15
Dual Rx   0
Current audio packet size   20
Current audio quality   0 - alaw 8 kHz
External IP   74.89.231.113
SIP Out port   30176
SIP In port   5061
Audio Out port   30178
Audio In port   11000
Command Out port   30177
Command In port   12000
External SIP In port   5061
External Audio In port   11000
External Cmd In port   12000
Other party   206.208.180.162
Input 1   High
Input 2   High
Output 0   Low
Output 1   Low
Output 2   Low
Dynamic DNS status   OK
Ping status (watchdog)   Off
DNS status   OK, remoterig.com = 193.202.110.185
Active profile:   HBOTest
PTT status:   OFF


Pages: [1]