Show Posts
1
General discussion forum / Wireless Device (eg. Phone, Pads) - Program Mode
« on: 2012-03-26, 16:30:56 »
RRC-1258
Which Program Mode I should use when sending data from a wireless device (such as phone, Pads, or any other programmable device connected to the network)? 0 or the one specified for the Radio (K3, Kenwood, etc). I am planning to use Remote Rig (Only One unit) to remotely operate the radio wireless in the same building.
If that possible? or I need another RRC-158 to send commands to another RRC-158 ?
Thanks
Jose L Rivera
Which Program Mode I should use when sending data from a wireless device (such as phone, Pads, or any other programmable device connected to the network)? 0 or the one specified for the Radio (K3, Kenwood, etc). I am planning to use Remote Rig (Only One unit) to remotely operate the radio wireless in the same building.
If that possible? or I need another RRC-158 to send commands to another RRC-158 ?
Thanks
Jose L Rivera