Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Ed

Pages: [1]
1
General discussion forum / Configuring DX Lab to send keyboard/macro CW
« on: 2016-07-23, 00:02:32 »
Both N1MM and DX4WIN allow me to use the virtual COM 1 port In my case the RRC created COM 5. DX Lab will not allow me to to use a single COM port for two different operations. Just  says Port i Use, can not open. Anyone having success?

Pages: [1]