Topics

1

Configuration, RRC 1258 / K3/o mini 3 tone error on power on

« on: 2023-02-13, 22:48:33 »

When I connect the k3/0 mini and power on I get a continuous 3 tone error code[ payaing repeatedly.
All cables are correct.
Does anyone have any ideas what might be wrong?

Thanks
Hugh EI9KF

2

Configuration, Webswitch 1216H / Serial settings for Steppir

« on: 2015-05-10, 18:28:19 »

I am using a SteppIr SDA 100 controller.
The setup instructions show a Serial Setup page where the baud rate, parity etc is selected .
My software version (4.16) says "no setttings available for this device" when I select Serial Settings.
What am I doing wrong? Is there a default for the baud rate?
Thanks
Hugh

3

Configuration, Webswitch 1216H / RC 1216H control problem

« on: 2015-04-29, 21:32:14 »

I have installed the latest firmware 4.16.
When I enter the web control screen, it only gives me options for Rotator control.
I need to use the device to control a Steppir Antenna
This option is not available to me.  Can anyone help?
Hugh EI9KF

4

Configuration, Webswitch 1216H / Accessing 1216h

« on: 2015-04-21, 23:14:07 »

Here is a pretty basic question.
I have set up my 1216h, given it port 8001 on the router. I have a fixed IP address.
How do I access the 1216 remotely?
What address do I enter into my browser to get in? This is not mentioned in the documentation.
Thanks
Hugh EI9KF

5

General / New setup with K3

« on: 2015-03-03, 19:46:00 »

I feel quite foolish ..but really cannot understand the instructions. "If you have a Elecraft  K3, KX3  or a K3 twin setup, connected via a CAT cable from COM2 " ..What does this mean? Do you mean the K3 should be connected to the COM2 socket on the RRC 1258 Control Unit (normally not in the shack) ? The remote Radio unit only has a COM1 plug on it.  My K3 is linked to COM2 on  my PC.   I there any chance that I could have a small join-up diagram? I am reallty quite confused.  Thanks for the help.