Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - gcarver

Pages: [1]
I have had the above problem for a while.  I totally agree with Eric .   I am using the Pepwave surf 200.  I turn off the wifi on the computer.  Then go to IP for the surf and sign in to the hotel wifi.  This brings up the portal on your computer. You then move the ethernet cable to the remoterig after maneuvering  through the portal  and the remoterig  works.  The surf 200 acts as a wifi client and since it has NAT, devices behind it will automatically connect the hotel wifi.  Hope this will add some helpful info to Eric's explanation (which is excellent).  It's simple but those of us who are not IT techs can miss it easily.  Ports in the hotel can block the remote rig also but I am using 5065 and have no problem.  Good luck.

      73,  Jerry   W4YB

Configuration, RRC 1258 / can not connect
« on: 2013-10-17, 16:28:14 »
I have been using the system with great success last few months but when preparing for another trip I find that I can not connect.  I reviewed the configuration in each unit and nothing has changed.  I reset my router and opened all the ports again just as before.  When I try to connect I can hear the Icom 706 click but I get nothing on the screen and no audio.  My firmware is 2.6.6 and I am connecting through my hotspot on my iphone.  Any help would be greatly appreciated.

Jerry,  W4YB

Pages: [1]