Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - OE1KBC

Pages: [1]
1
General discussion forum / RRC PC-Client virtual com ports
« on: 2010-10-15, 09:30:13 »
Hi,
alter testing the RRC PC-Client Dongle in serveral computers - i can not connect to the com ports.
I´m using over all the very last Firmware and Software. The connection takes place and the audio
transfer is ok in funktion. Also the PTT is working (I have a remote camera - so i can see the red
light on my remote Elecraft K3)

The old way with the RRC Client Box is also still working. I use the same LAN cable (change it from
the RRC Client to the Computer - same firewall and so on)
I´m using HRD 5.0 beta and even a homemade sotware for the remote antenna tuner. Both programms
state "can not open COMx port".

I´ve tried to switch off the Windows Firewall (Windows XP Prof. SP3) nothing changed.
Please give me more information to bring the com ports running.

73 de Kurt
OE1KBC

2
General discussion forum / HF distortion in audio
« on: 2010-03-04, 20:26:49 »
Hi all,
my remote K3 with HRD via COM2 and remote Tunercontrol via COM1 is working pretty good in receive mode.
I can send up to 10-12 watt with clear audio. But over this point only extrem hiss is heard on the modulation.
A second test: When i set the K3 in tx mode and play from my internal voice recorder fine modulation up
to 100 watt is transmitted.

I set a ferrit clamp on the shielded mic/ptt cable and on the 12v power cable. nothing changed.

73 de Kurt
OE1KBC


3
General discussion forum / ICOM ID1 - 23cm, DV Transceiver
« on: 2010-02-01, 23:50:08 »
Hi all,
as my ICOM 2820 is working very well remotly, i´ve made a pair of cables to connect
my ICOM ID-1 remotly. I´ve used the same radio setting (9=2820).
But it does not work. It seems to have not the same protokoll or the same baud rate?
When i use radio type 1 = ICOM i can transfer audio with the same set of cables but
the RC-24 (controlunit) stay with no light and no display.

Any solution out there?

73 de Kurt
OE1KBC

4
Hi all,

I´ve configured a connection with my IC 2820 RIG. It works absolutly fine in commands and audio.
I made several QSO via DSTAR and FM Repeaters.

But after few Minutes (2-5) the Control switch the IC-2820 Unit off. I have to start once again with
the PWR button. then i can stay stand by few minutes again.

Both Remote Control Station are on a cable internet connection which is also used for our main
internet connection 20 MBits/Down 2 MBits/Up on both sides.

Any Idea?

73 de Kurt
OE1KBC

Pages: [1]