Show Posts
1
General discussion forum / Remoting the K3
« on: 2010-02-18, 13:11:56 »
Hi,
I am interested in remote controlling the Elecraft K3 and have a few questions...
1) Are the audio codecs mono or stereo? The K3 with a secondary RX produces two audio streams, so a purely mono codec would be a disadvantage.
2) Are there any plans to fully support the entire K3 remote protocol <http://www.elecraft.com/manual/K3_Programmer%27s_Ref_C9.pdf> to enable full control of the rig? The typical Kenwood protocol would only control a subset of the K3's functions.
3) If one needs to control several pieces of equipment, e.g. rig, rotor, PA, power meter, power supplies and antenna switches, simultaneously what might be the best way of doing this using the RRC-1258MkII & WEB-Switch 1216E?
4) Does anyone have any experience with digital modes using the FSK input (PSK31 & RTTY) and decoding the audio after it has been transported over the internet?
vy 73 de DD5FZ
I am interested in remote controlling the Elecraft K3 and have a few questions...
1) Are the audio codecs mono or stereo? The K3 with a secondary RX produces two audio streams, so a purely mono codec would be a disadvantage.
2) Are there any plans to fully support the entire K3 remote protocol <http://www.elecraft.com/manual/K3_Programmer%27s_Ref_C9.pdf> to enable full control of the rig? The typical Kenwood protocol would only control a subset of the K3's functions.
3) If one needs to control several pieces of equipment, e.g. rig, rotor, PA, power meter, power supplies and antenna switches, simultaneously what might be the best way of doing this using the RRC-1258MkII & WEB-Switch 1216E?
4) Does anyone have any experience with digital modes using the FSK input (PSK31 & RTTY) and decoding the audio after it has been transported over the internet?
vy 73 de DD5FZ