Topics

1

Configuration, RRC 1258 / Control RRC-1258 has died :-( Help!

« on: 2015-06-30, 20:51:00 »

Just cam home and powered up the control RRC on an Elecraft K3 twin system.  Green light never stops blinking and there is no LAN connection via ethernet or WiFi.  I can get into the RRC using the setup utility and see that all the WiFi settings have been wiped and there is no IP adderess being picked up from the DHCP via ethernet or WiFi.  Rentering the WiFi credentials does nothing.
Done a reset and reflashed the firmware (2.83) nothing.  I get a green light on my router showing at least at a hardware level the ethernet port is working, but no MAC address for the RRC visible on router.
Seems the brains in the box have turned to jelly and I am off air :-(  has been working fine for almost a year up till now.
Need help!
Justin, G4TSH

2

General discussion forum / Webswitch Serial Port to control Alpha 87a?

« on: 2014-09-20, 22:22:19 »

Is it possible to use the serial port on the Webswitch to remote control an Alpha 87a using the Alpha remote software?  Advice on setup/config to use the Serial/Com port on the 1216H or even RC1216H? welcome.

73
Justin, G4TSH

3

Configuration, RRC 1258 / RRC control will not connect to WiFi

« on: 2014-09-18, 22:07:23 »

I have a Elecraft K3/0 mini and RRC pair working great using wired Ethernet at the control end.
I installed the WiFi module and antenna, configured with the Microbit Setup manager.  However it steadfastly refuses to connect to my routers AP (Netgear DGN2000).  It can see the router SSID in the WiFi scan and I can add the SSID and password to the setup list.  But after reboot, there is no connection made to the router AP. 
The router does not see the RRC on the list of potential devices.  Have double checked that the MAC address of the RRC is on the permitted list of the AP.  Also trying WPA-PSK and WPA-PSK2.  Other WiFi devices work OK.  Ethernet cable is disconnected when attempting WiFi access.
Any idea what else I should check?

Thanks
Justin G4TSH

4

General discussion forum / KRC2 Band Decoder on remote K3

« on: 2014-09-15, 23:16:54 »

Does anyone know if it is possible to use the KRC2 band decoder on the serial port between the RRC and a K3 at the remote site and use it to switch antennas?  I presume I will have to use a slower baud rate and Kenwood protocol.

73
Justin G4TSH