Topics

1

General / Icom nano

« on: 2017-09-22, 23:34:17 »

I run both the kenwood and icom nano app. I see with my ts-480 I can use my antenna tuner but no option to do the same with the icom app with my ic-7100? Any way to run the antenna tuner with icom nano? If not can this feature be added?

Thank you!

Bill ng1p

2

Hardware, Cabling, Installations / Wireless Card issue?

« on: 2017-01-04, 19:59:30 »

I got a pair of remoterigs for Christmas. I first updated the firmware to the latest version. The radio side is connected to the wired network via ethernet and the control side is using the Microbit wireless card.

The problem I am seeing is when I power down the control RR and then power it back on it doesn't always connect back to the home wireless network. I have to unplug the power cord and wait a few minutes and then power it back on. Some time I have to go thru this 3 to 5 times before it connects. I see the samething when I use my phone as a hotspot. Did I get a bad wireless card? I would assume this should just work every time. I have tried this with 4 other wireless routers and I get the same effect everytime. Sometimes its works the first time but normally its a 3 to 5 power on/off event.