1
Configuration, RRC 1258 / Strange connection problems
« on: 2018-02-22, 01:27:09 »
I'm currently using a K3/0 to connect to to a remote K3 and may be experiencing an RRC hardware problem at the remote end. It was working just fine for a couple of months and then all of a sudden I couldn't get any logging software to find the rig. That went on for a month and then the remote K3 completely disappeared and the K3/0 stopped with "TERM" displayed on the screen. I've tried several times over the past 2 months to connect with no success. 3 days ago I turned the K3/0 on and hoped for a miracle. Bingo! It connected perfectly and I was able to operate. However, logging software still can't find the K3 so I think I'm still on thin ice just waiting for another complete failure.
I think I've checked all setup items and they appear to be correct. The only things I can't figure out are the I/O settings on both remote and local. They are set to OFF on the remote and I/O on the local (OUT0 Mode is "Connect"). I don't think any of these settings are causing my problem, but really don't know.
Does anyone have any ideas where I might go from here or will I need to be back at the remote station to troubleshoot?
73,
Mike - W0AG
I think I've checked all setup items and they appear to be correct. The only things I can't figure out are the I/O settings on both remote and local. They are set to OFF on the remote and I/O on the local (OUT0 Mode is "Connect"). I don't think any of these settings are causing my problem, but really don't know.
Does anyone have any ideas where I might go from here or will I need to be back at the remote station to troubleshoot?
73,
Mike - W0AG