Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - G3VAO

Pages: [1]
Configuration, RRC 1258 / Is Ftdx 3000 supported?
« on: 2018-02-09, 17:55:49 »
I have been struggling to get a Traditional PC-remote control working and it was recently suggested that the FTdx 3000 may not be a supported radio.  Can anyone confirm that it is supported?


I have been attempting to set up a remote facility using my FT3000 / Remote Rig Hardware and Logger 32.      At the moment I have all the kit in my shack connected via an ethernet hub.  I have got the TX and Rx audio paths working and can key the Tx from the remote position, but (using L32) I am unable to control the radio from the remote location.   Has anyone got experience of this combination who can offer some advice. 
My PC and networking knowledge is fairly limited so replies in simple English would be appreciated!  I will be repeating this request for help on the L32, FTdx3000 and Remote Rig groups as I have been unable to identify the most likely problem area.

Mike G3VAO

General discussion forum / Remote Rig Config
« on: 2017-10-02, 17:45:32 »
Has anyone got experience of using the FTdx3000, RRC 1258, Logger 32 and N1MM.
Most of the forum seems to refer to HRD Log so:
1. How easy is it to use L32 and/or N1MM
2. What needs to be changed when going from L32 to N1MM and vice-versa

Mike G3VAO 

Pages: [1]