Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - LB2LG

Pages: [1]
1
General discussion forum / RF NOISE AT 2-4 Mhz
« on: 2020-03-01, 19:10:03 »
I have operated my remoterig for half a year now. The radio part is in my cabin, far out in the woods where there is normally noise-free at HF. After installing the remote part I struggle with 5-7 S in noise. I have taken "the circuit breaker" test and - not surprisingly - found that the noise comes from the equipment connected to remotrig. Power supply for remote and WIFI router does not seems to noise, but I suspect that the WIFI router emits unwanted noise. Someone who has experience with it? I've read here on the forum that the Ethernet cable emits noise. Can it be a solution and install WIFI on remoterig?

2
Jag köpte en Remoterig RRC 1258 Mk 2 i Eskilstuna i april. De fungerar perfekt när de är anslutna till det samma LAN.

När jag ansluter radio-RRC till min TP-Link Archer MR200 4G-router, fungerar den inte.

Radio-RRC-inställningar:

- DDNS OK
- SIP-kontakt OK (min xxxxxxxx.ddns.remoterig.com-adress är fylld i här.)

Router:

- DMZ på och Radio RRC IP-adress (192.168.1.228) är fylld i här.

- Port Forwarding som angiven i manual

- ALG OFF

- Internetleverantör/ISP - Telenor mobil 4G använder inte CGN

När jag kontrollerar http://ddns.remoterig.com/status får jag samma IP-adress som Internetleverantören har angett min TP-Link-router.

När jag försöker sätta på min TS480 låter ett "Euro-ljud" i Control-RRC (ingen kontakt nås)

När jag går in i xxxxxxxx.ddns.remoterig.com i en webbläsare, kommer jag inte in i Radio-RRC. Förutom när webbläsaren är på samma LAN som Radio RRC.

Finns det en inställning i min router som jag har glömd?

Goda råd mottages med tack!

(förlåt för mitt "Svorsk")

73 de la LB2LG / SA4YOU

Pages: [1]