Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - sv1elf

Pages: [1]
1
General discussion forum / I/O settings for K9AY
« on: 2017-01-25, 17:43:10 »
Hello everyone
Does anybody know the settings for I/O to control k9ay antenna
with version up to 2.87
Thanks

2
General discussion forum / ts-590 twin
« on: 2014-11-11, 06:33:19 »
Hello to all
Does the RRC-1258MkII ( not "S" ) also works for TS-590 twin setup ?
Thanks
George

3
Configuration, Webswitch 1216H / ERC rotor card
« on: 2014-07-25, 20:47:30 »
Hi
I have the webswitch 1216H  with two temperature sensors on it,
and I  want to add the ERC Rotor control ,to control a Yaesu 800 rotator.
My question is if it works together the  temperature sensors and ERC , and in rotator menu what
rotor I choose , DCU1 ?
73 de George

4
Hi
Does anyone have try to work W2 wattmeter(elecraft) or LP-100A via RRC 1258 com port ?
Thanks
George

5
General discussion forum / ft-8800
« on: 2012-05-01, 12:03:16 »
Hi
I suppose that the new firmware  works also with Ft 7800
Can anyone test it ?
73 de sv1elf
George

6
General discussion forum / State contacts of web switch
« on: 2012-02-29, 08:42:14 »
Hi
I wonder if in any older vercion there's a possibility
or its regular , the contacts state return to off  state after
(12v) power loose.(in case that you loose and internet and you
don't have communication to control the web switch).
Thanks
de sv1elf
George



7
General discussion forum / com 1 cat with ts480
« on: 2011-10-23, 11:50:08 »
Hi
Can anyone tell me whats going wrong and i cant use com1 as cat for logging program ?
Using ts-480 , serial settings -mode4 -9600.... com1 doesn't work , when i try to com 2 works fine.
Thanks
sv1elf George


8
General discussion forum / serial com port for remote cw
« on: 2011-04-11, 14:34:55 »
Hi
Does anyone try to use the serial port  with interface , to remote side  for cw in cw jack of ts-480  ?
In other words to use a remote "serial port "
Thanks
George

Pages: [1]