Show Posts
1
Configuration, RRC 1258 / Config/Setup - No Devices Found!
« on: 2019-09-27, 06:22:53 »
Sorry if I did not pick the right forum to post this.
I already have been successfully using Remote Rig with my Elecraft radio for a couple of year. I just bought another set of Remote Rig boxes, to have as backup. All of my cables and such have been working fine. I’m just dropping in the “new” box to setup.
I cannot get my “new” Remote Rig control box to show up on my network.
I can successfully access it via USB. I even upgraded the firmware (from 2.91 to 2.95) by USB. So I know I’m not totally locked out, which is good. However, when I try “Find Devices” it never sees the control box, just the result of “No Devices Found!”.
An interesting fact, that I think will help someone, in figuring out my problem, was the very odd settings (had through USB) for the network settings on the Remote Rig on first start. The serial number (on screen) was 10 digits long! (the actual serial number on the box, is only 5 digits long). The MAC address looks like appropriate hex numbers. The IP Address, Subnet Mask, Gateway and DNS Server addresses were all 255.255.255.255
I changed all of the values to appropriate values that I’ve been using already in my original Remote Rig box, but can’t see it on the network (“No Devices Found”). I’ve also tried changing to DHCP, with no success.
I’ve tried searching the forums here and the only relevant thread I could find was this one: http://www.remoterig.com/forum/index.php?topic=5632 I tried the instructions there from Mitch, but they didn’t get me any success.
Any suggestions on what I can do?
Thanks – 73
Graydon
I already have been successfully using Remote Rig with my Elecraft radio for a couple of year. I just bought another set of Remote Rig boxes, to have as backup. All of my cables and such have been working fine. I’m just dropping in the “new” box to setup.
I cannot get my “new” Remote Rig control box to show up on my network.
I can successfully access it via USB. I even upgraded the firmware (from 2.91 to 2.95) by USB. So I know I’m not totally locked out, which is good. However, when I try “Find Devices” it never sees the control box, just the result of “No Devices Found!”.
An interesting fact, that I think will help someone, in figuring out my problem, was the very odd settings (had through USB) for the network settings on the Remote Rig on first start. The serial number (on screen) was 10 digits long! (the actual serial number on the box, is only 5 digits long). The MAC address looks like appropriate hex numbers. The IP Address, Subnet Mask, Gateway and DNS Server addresses were all 255.255.255.255
I changed all of the values to appropriate values that I’ve been using already in my original Remote Rig box, but can’t see it on the network (“No Devices Found”). I’ve also tried changing to DHCP, with no success.
I’ve tried searching the forums here and the only relevant thread I could find was this one: http://www.remoterig.com/forum/index.php?topic=5632 I tried the instructions there from Mitch, but they didn’t get me any success.
Any suggestions on what I can do?
Thanks – 73
Graydon