Topics

1

General discussion forum / working WITHOUT dyndns

« on: 2011-02-23, 22:37:39 »

Hi,

i have the chance to install my Radio on the roof of an university.
I have some questions about the configuration of the boxes.

My last succesful configuration was with dyndns and two routers
like this:

Control settings:

Sip contact   XXXnk.dyndns.org

Radio settings:

IP           192.168.XXX.228
Netmask   255.255.255.0
Gateway   192.168.XXX.1
Dns server   192.168.XXX.1
Extern IP/Host   91.49.XXX.233

Own host name   XXXnk.dyndns.org

But NOW, i will become from the IT of the university the following datas for configuration:


web account    afu-kw.XXX.hs-bremen.de

IP            194.94.XXX.184
gateway   194.94.XXX.190
netmask    255.255.255.192

Ok, netmask, gateway and IP i have to fill in by the settings of the radio box - no problem.
But what do i have to do under control settings with SIP contact?
And also what is to do in the radio box with DNS server, Extern IP/Host and Own host name?
And where do i have to fill in the server adress afu-kw.XXX.hs-bremen.de?

Last question: are there any other important settings i have to consider?

On your answers i will be happy

73

Kai

2

General discussion forum / Problems between UMTS and DSL

« on: 2011-01-21, 22:59:45 »

Hi,

i tested a TS 480 in my LAN. I tested only power on and it works.

Then i use my notebook in lan-bridge-mode, connecting RRC control via cross over cable and
using a UMTS stick in USB port.

On radio side i connected RRC radio to Fritz Box 7050 DSL Router . Using port forwarding.
Can`t find something about DMZ = enable, testing with "exposed hosts" 192.168.0.228.

By the way: all cables connected, but not the MIC cables on both sides of the RRC

After testing POWER ON at TS 480 the result is: yellow LED AUX/MIC is flashing
an i hear an error code (dit dät döh), 
I looked for SIP contact under Radio settings of control RRC: there stands from the
last test in LAN the IP of radio RRC 192.168.0228. I changed in dyndns host name
like myadress.dyndns.org - but also the same error, no connection

under status i find: dns status = error, failed to resolve remoterig

Only one positive test:
from UMTS side via Internet i connected the RRC radio box with http://myadress.dyndns.org:58

Any idea where is the mistake?
1.) UMTS stick connection via lan bridge configuration of the notebook
     or (any other idea how to use a notebook with UMTS stick on control side?)
2.) settings of the RRC`s?
     or
3.) setting of the Fritz Box Router?

73

Kai


After this (restarting)

3

General discussion forum / update firmware V 2.30

« on: 2011-01-02, 01:15:38 »

Hello,

i make my first steps with the RRC´s and i have problems to update the firmware.

I have connection via USB and can read the info, that i have V 2.28.

By starting the update (.bin-file was located on my PC), after a few seconds i become an error message: ...writing failed.

Any idea please?

73

Kai