Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - rikpal

Pages: [1]
1
I've tried succesfully the R2500 with RRC1258MkIIs and the icom supplied remote control panel.

My problem is that the functionalities through the remote panel are limited and via sw it is easier, more user friendly and more functionalities are available (e.g. the signal spectrum).

So, I'd like to use a software (?) + the RRC1258 (better the RRC micro PC client) to control remotely my R2500.

Unfortunately, as you may know, ham radio deluxe (HRD) does not support the R2500 and any trick described on the net to mask it as a PCR1000 (supported by HRD), under win 7 does not work at all.

the ICOM original provided SW cannot be used, since it has proprietary USB drivers that require the receiver to be plugged on locally on the laptop on which the sw is executed, so another option vanished. On this regard, I tried succesfully to remotize the USB (thorugh a specific sw), but not the 2 COM ports (commands and audio), that is what RRC should be able to do ...

So, now my idea is to try to use another sw I just purchased, th Bonito RadioCom 6.x, that I have not yet installed and tested, but I understood it should just use a com port for CV-I commands (I'd like to use that one provided by the RRC1258 as shown in a generic Icom CV-I configuration) and then the audio, that should be covered by the RRC itself (maybe, I should pass it to the laptop sound card, and use it with the RadioCom 6?).

Any suggestion from your side?

If this configuration could work, it would e wonderful.

Thx in advance for any help you would like to provide me.

2
Is there any way to protect the communication between two RRCs? I mean apart from the password.
I imagine that if I use the PPC Client, I can go through a VPN, since I use a PC, but what about when do I use 2 RRC? I'v to expose to the router the 3 ports, but communications are not encrypted. Am I correct?
regards.

3
I'd like to know how to use the I/O connectors and just few examples of electronic circuits to transfer some I/O signals between the 2 RRC.
e.g. if I switch on a contact on the RRC-control, how to activate e relay on the RRC-Radio, or how to get a relay or led on on the RRC-Control, activated by a status signal on the RRC-Radio. Which supply should I use? I suppose the 8V on the connector are non enough to use relays...
Idas about which other ways could I use these I/O signals (apart from keyers, CW pads, etc.).
could be this one a replacement of the webswitch?
I really appreciate.
thx in advance.

Pages: [1]