Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - oh3bjl

Pages: [1]
1
Hardware, Cabling, Installations / CW speed knob mod in V0.1
« on: 2014-09-10, 19:28:42 »
Hi.

I have RRC-1258 V1.0 and I've made CW mod for it, i.e., I installed the missing CW speed potentiometer into my control box. I followed the mod instruction given on remoterig web pages (http://www.remoterig.com/v1/en/cw_gen.htm). Knob has been installed but nothing happens, the CW-speed doesn't change thougt I rotate the knob. What's wrong? My firmware version is 2.80 and the controlled radio is IC-706 mk2g.

2
Hi.
I have RRC-1258 boxes version 1.0. I have problem with my control unit. I'd like to reconfigure it but I cannot connect to it either via Ethernet nor via USB  (PC <-> control unit). I have tried to reset the unit to default settings (long reset abt 18 secs) but there seems to be something wrong. When I reset my radio unit, it works fine, and I can connect to it with my PC and I can make settings by using the RRC unit's web interface. But when I try to reset the control unit, the leds flashes differently compared to the radio unit and the radio unit gives no responce when I try to connect to it by using my PC's web browser. So, is it possible that the firmware of the control unit has been corrupted and how could it be fixed to get the unit working again?
73 Kari OH3BJL

3
Hi.

Is it possible to control via internet other ICOM radios than only IC-706's
by using the package configured for IC-706. For instance, can I use this package
to control, for instance, IC-756proIII, so that I use PC and HRD at the operator end?
How about other manufacturer's radios?

73, Kari OH3BJL

Pages: [1]