Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - ea7rm

Pages: [1]
1
General discussion / Virtual coms under Win 7
« on: 2016-05-25, 13:13:07 »
Hola to all,

i think i am having problems installing Virtual Ports under Win 7.

I´m using

RRC-Micro 1.9.2.0
Dongle 1274B 2.1.0.0 Frimware
RTP 1.2.0

Win 7 Pro

I  followed all the steps in the installation and Setup guides for the Software Micro-rrc. I can see the Virtual Ports under Windows Device Manager but when connect HRD always gives an error trying to read freccuency.

I have deleted all the Microbits Ports using the MicrobitDeviceManager utillity and reinstalled the rrc-micro software again, always under Administrator privileges, but always have the same symptoms later with HRD.

Any Help will be wellcome, i must be doing something wrong.

Thanks in advance
Nino, EA7RM

2
Hola to all,

I just changed to a new router at control side in the same net i have been using lately, made all the initials settings configuration as always i made before in others routers, but with this one i have no audio into my TS-480.

I have read the forum and i tried to change sip port with no success.

Firmware is updated to last version

This is what appear at status RRC control.




Any idea  ?

Thanks in advance, 73s, Nino, EA7RM

3
Hola to all,

Managed to setup Alfaspid rotor via COM2 sucesfully but since i need COM2 for CAT control and cw keying via PC i tried to change ALfaspid to COM1, but everytime i plug the connector into COM1 of RRC-1258 box  the rotor start to move to left side. i´m using the same wire as worked with COM2.

Any suggestion ?

Thanks in advance
73s, Nino EA7RM

Pages: [1]