Topics

1

Configuration, RRC 1258 / RRC and the Icom 9100

« on: 2012-04-01, 21:34:03 »

Jan,
Trying to get the RRC to work with the Icom 9100 using a pair of RRC1258 mkii and the Icom RS-BA1 remote control software.

The Radio RRC connects to the Control RRC but the RS-BA1 software does not find the radio.

I have the Icom software and the radio set to match the RRC at 9600 bps com 1 N81 . Icom software and radio use 7C as the CI-V address.  There is also an address setting for the CI-V RS-BA1 in the BA1 setup. It is currently set to E0.

I have attached my two RRC  unit configuration files. Could you have a look to be sure I have them configure properly?

Is there an easy way to tell if the control unit is talking to com 1 ( and the icom software or the connection utility) on the laptop at the remote end?  There are so many places that I might have missed something its hard to divide and conquer.

Thanks for your help!

2

Configuration, RRC 1258 / Error 31 while upgrading

« on: 2012-01-10, 18:30:14 »

I have 3 sets of the RRC1258MkII.

The first two sets FW upgraded with no problem using USB.

The third set will not upgrade FW using USB. I get the Error 31 message.

After failing trying USB, I was able to upgrade the 3rd unit's FW using the web, I think, But usb still is dosen't work.

The revision of boot loader on the failed unit says N/A and FW is now version is 000.000.002.050 unlike the other two sets that report firmware is 2.50. and boot loader is 1.9. HW is ver 6 on all sets.  Have not tried to config this unit for radios yet, but the other two are working well.

How do I fix the missing bootloader and FW revision number?