1
Configuration, RRC 1258 / Re: Yaesu FT-991 Setup
« on: 2017-01-15, 16:36:58 »
Dear OM,
Did you manage in the end to get it to work?
73e Michael
PA5M
Did you manage in the end to get it to work?
73e Michael
PA5M
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
General discussion forum / Re: Error upgrade RRC with software version 2
« on: 2010-01-07, 16:38:10 »
OK got it going now.
For the upgrdae of the radio interface box, I didn't use the flashing SW.
I just went to the interface webpage and slected Application upgrdae.
Simple as that...
73e Michael
PA5M
For the upgrdae of the radio interface box, I didn't use the flashing SW.
I just went to the interface webpage and slected Application upgrdae.
Simple as that...
73e Michael
PA5M
3
General discussion forum / Error upgrade RRC with software version 2
« on: 2009-12-30, 21:35:38 »
Perhaps I overlooked something.
But I can't get the radio interface to be upgraded with SW version 2.
The control interface upgrade worked out fine.
I am connecting via IP to the radio unit and select Application upgrade.
Then I select version 2.bin file.
The error on the radio interface web screen shows "CRCR32 mismatch, header=987218507, calculated=470647787".
What went wrong here
73e Michael
PA5M
But I can't get the radio interface to be upgraded with SW version 2.
The control interface upgrade worked out fine.
I am connecting via IP to the radio unit and select Application upgrade.
Then I select version 2.bin file.
The error on the radio interface web screen shows "CRCR32 mismatch, header=987218507, calculated=470647787".
What went wrong here
73e Michael
PA5M
4
General discussion forum / Remote rig and HRD/Supercontrol, display issues
« on: 2009-11-03, 13:31:32 »
When I was testing my FT-857 with HRD and also with Supercontrol.
I found that the display reading in both programs is unstable.
Most of the time the reading was incorrect with a lot of "b7C#" bla bla.
The TX/RX function in Supercontrol was also tested at the same time and it worked without problems.
I changed the baudrate settings, etc, in both the interfaces and the programs, but without luck.
Good to mention that I was doing those tests on my internal (1GB) network, so no delays occurred.
Has anyone got ideas how to get a proper corresponding display ?
73e Michael
PA5M
I found that the display reading in both programs is unstable.
Most of the time the reading was incorrect with a lot of "b7C#" bla bla.
The TX/RX function in Supercontrol was also tested at the same time and it worked without problems.
I changed the baudrate settings, etc, in both the interfaces and the programs, but without luck.
Good to mention that I was doing those tests on my internal (1GB) network, so no delays occurred.
Has anyone got ideas how to get a proper corresponding display ?
73e Michael
PA5M
5
General discussion forum / Re: Software control side
« on: 2009-11-03, 13:18:29 »
Dear OM,
As far as I can remember SM2O was planning to come up with such a solution.
However no time frame was mentioned...
73e Michael
PA5M
As far as I can remember SM2O was planning to come up with such a solution.
However no time frame was mentioned...
73e Michael
PA5M
Pages: [1]