Messages

1

General discussion forum / Re: Remote end becomes inaccessable

« on: 2016-10-02, 11:44:41 »

It happens here several times per day. Radio still works, but WEB access to the Radio RRC is impossible. I have the ping reset option enabled, but it doesn't help. I added a programmable timer AC outlet that reset the unit every night, but operation is quite difficult during the day.

Alberto I2KBD

2

General discussion forum / Re: Problem with I/O pins

« on: 2016-09-18, 08:57:01 »

Hi Mike,
yes the problem is solved. The misunderstanding was with color codes of the RJ-45 cable.
Many thanks for support!

Alberto I2KBD

3

General discussion forum / Problem with I/O pins

« on: 2016-09-01, 17:35:27 »

Hi all,
while trying to control my Acom amplifier using the I/O output lines, I found two big issues.
On the Radio side, pin definition on the WEB interface is swapped, i.e. OUT0 controls Output 2 and OUT2 controls Output 0.
Moreover in the WEB status page Output 1 and Output 2 are also swapped.
I got crazy for a week not being able to understand why I couldn't control the amplifer (of course I added pull-up resistors to 8V).
Anybody else faced this issue?

Regards
Alberto I2KBD

4

Configuration, RRC 1258 / Re: TS-480 CAT one way

« on: 2016-02-17, 12:24:37 »

Hi Jan,
thank you for your reply. If I connect the CAT serial to the COM2 port on the Control RRC, all is working fine.
It's the USB emulating the COM2 port that fails to work in one direction.

Regards
Alberto I2KBD

5

Configuration, RRC 1258 / Re: TS-480 CAT one way

« on: 2016-02-15, 21:04:52 »

THIS IS THE ERROR CODE:

15-feb-2016 19:59:43 > program error 8020 in module CIVComm.ReadPortText: Error reading comm device

6

Configuration, RRC 1258 / TS-480 CAT one way

« on: 2016-02-15, 12:50:37 »

Hi everybody,
I am using Commander (DXLab suite) to control the CAT of my TS-480.
Radio RRC to COM2 and Control RRC using the USB port.
Commander controls the radio with no problem (frequency and mode) but cannot receive frequency from the rig, when I move the dial manually. There seems to be a problem in receiving data from TS-480 CAT, but sending is ok.
PC is running Windows 10.

Any suggestion?
Alberto I2KBD