Messages

1

General discussion forum / Re: Kenwood ts-480 Sat

« on: 2017-12-04, 22:06:05 »

So do you have to have the boxes hooked up to a computer to do that program change? Sorry I wasn't here when this was installed and am not familiar with this at all.

2

General discussion forum / Re: Kenwood ts-480 Sat

« on: 2017-12-04, 21:51:20 »

What is the one setting you are talking about?  I did the jumper wires and the the jumper pins?  as described on page 185 our IT guys checked my work and they said it looked correct per the paper.

3

General discussion forum / Re: Kenwood ts-480 Sat

« on: 2017-12-04, 20:01:57 »

It has a ethernet box at each end with fiber ran between the boxes, which ties into the Rig Remote boxes.

4

General discussion forum / Re: Kenwood ts-480 Sat

« on: 2017-12-04, 20:00:51 »

Our IT/ Data guys looked at the factory Kenwood cable and made me two shorter versions which both work fine head to radio, not sure what I am doing wrong on this.

5

General discussion forum / Re: Kenwood ts-480 Sat

« on: 2017-12-04, 15:09:21 »

So I have to hook up the units to the computer and update them?  I just placed them side by side and hooked a short cat cable between them still nothing?  The jumpers are set to the specs on pager 185 of the manual.

6

General discussion forum / Re: Kenwood ts-480 Sat

« on: 2017-12-01, 21:06:12 »

Am I supposed to do any software type update? 

7

General discussion forum / Re: Kenwood ts-480 Sat

« on: 2017-12-01, 20:56:04 »

it had one jumper on the radio side that the book didn't call for and I Jumper 1 off, 2 on 3 on and no number 5 on the control head.

8

General discussion forum / Re: Kenwood ts-480 Sat

« on: 2017-12-01, 19:53:47 »

I just tried it and no good.  I am using the info off page 185 in the manual, for Kenwood ts-480?

9

General discussion forum / Kenwood ts-480 Sat

« on: 2017-12-01, 16:57:38 »

I work at a hospital and we had a ts-2000 set up on the 9th floor tied into a RRC-1258 MkII, that hits a router and is fiber optic cable down to our control room on the ground floor, no internet connection hard wired from point A to B.   We really struggle with the ts-2000 and the remote head as it has tons of sub menus.  We have purchased a ts-480 Sat for its simplicity,  I have followed the plans on line and have all the jumpers in place except Jumper #5 which I don't seem to have on my older model.  It calls for it in the ts-480 set up??  What do I need to do?  Proceed or do I need something else?

Thanks
Brian
K0ATZ