Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - OE5FHM

Pages: [1]
1
General discussion / Virtual COM1/2 Ports and rts cts
« on: 2013-03-10, 11:32:05 »
I have a problem with RRC micro and RCV7 Vers. 2
If I use an IP tor RS232 converter like Moxa xxx, the communication between the Software and TMV 7e works fine.
I installed the latest Firmware on RRC, RRC Micto and Setup manager.
I got 4 Virtual com Ports.
It makes not difference i connect to Com1 or Com2 on RRC.
The Software is missing CTS signal.
On the RRC Control, there is a Jumper allow to connect RTS and CTS.
In Virtual com there is no possibility to make this.
Set in Com “flow control” brings not the solution.
Is there any possibility to set a flag “RTS=CTS” ?

73 Helmut OE5FHM

2
General discussion forum / Re: Restet Webswitch1216E
« on: 2010-08-01, 10:29:49 »
Hi
I have solved the reset problem.
May fault was to ignore the serial number. This has to be set to the corrent.
You can only see the corrent serial number after opening the case.
I have not read the manual correctly. :)

3
General discussion forum / Restet Webswitch1216E
« on: 2010-07-29, 09:42:36 »
Hi
I changed the IP Adress with IPconfig. There was a fault message. After this message, I get not connection with the item. Aree the two 5 Pin plugs not used RS232 ports?

Pages: [1]