Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - n5xz

Pages: [1]
1
I hooked up the unit at home and, as you might have expected, *almost* no popping or dropouts. Using PingPlotter, I see a bad hop, so I'm not sure what to do about it, but I will be researching it.

Allen N5XZ

2
I haven't had a chance to try it at another location yet. I'll let you know.

Allen N5XZ

3
Mitch, I tried your suggestions and they made a slight improvement but not enough to make the connection smooth. Any other suggestions?

Allen N5XZ

4
Thanks, Mitch. I shall try your suggestions and report back.

Allen N5XZ

5
I have a new K3/0 & RRC1258 MkII setup to a remote K3. First time user. I get alot of "popping" noise, intermittent loss of audio and frequent need for radio resets. Not sure what I should do to try to mitigate the problems. Operating from an apartment, AT&T 100 mBit connection. I tried adjusting Rx jitter buffer size and Rx jitter delay but that had little effect. Suggestions?

Allen N5XZ

Pages: [1]