Messages

1

General discussion forum / Re: Audio stream stalls

« on: 2011-01-03, 20:02:21 »

Simon:
When I made the upgrade I was in the shack and I was able to see the status of both units side-by-side using the web-based programming setup.  What I noticed was the ports used for the audio were not the same.  I couldn't figure out if that was something I set or that it was dynamic controlled by the firmware.  Perhaps if you can watch the status of both units at the same time, you might get a clue as to what is happening.

For me, everything is working perfectly from the remote location so far.  That will be the last time, I upgrade a perfectly working system. Hi.

Good luck, 73 Dick, WN3R

2

General discussion forum / Re: No remote audio after v2.3 upgrade

« on: 2011-01-02, 16:08:11 »

Not sure what I did other than removing power, applying it again, and resetting the units a couple of times, but it is now working.  Thanks for everyone's help.

HNY es 73, Dick, WN3R

3

General discussion forum / No remote audio after v2.3 upgrade

« on: 2011-01-02, 15:41:41 »

I did the upgrade on both units with the new setup manager v1.8.  Now I have no audio.  It worked fine before the upgrade. I made no other changes.

Neither TX or RX audio is working.  Setup parameters look fine.

73, Dick, WN3R