Messages

16

General discussion / Re: Kenwood TS2000

« on: 2012-09-14, 23:46:20 »

Mike, I can now connect and can control the radio; however, i do not have any receive audio nor do I see it at the RRC-Micro panel.  I am using a standard audio cable (tip and ring only) from the radio to the RRC 1258. 

Tks Jerry
KA8D

17

Configuration, RRC 1258 / RRC 1258 Setup manager

« on: 2012-09-13, 18:49:50 »

Whenever I try to down load the setup manager for the RRC 1258, Norton  blocks it, removes it, and provides a malicious software message.  Do you folks know about this:

Jerry
KA8D

18

General discussion / Kenwood TS2000

« on: 2012-09-11, 06:27:56 »

I have a Kenwood TS2000 and am trying to get it to talk to the RRC micro client software/dongle.  I have the radio set to 57600 at the 1258 end, jumpers in place, TTL and speaker connections only at this time.  I am using com0 at both ends, SIP port 7805, CMD port 7803, audio port 7804, web server port 7800.  I had to change the port numbers as my cable provider is using 5060 for my VOIP home phone.  I have the mode at the radio end set to 7 on the com0 screen for the Kenwood 2K.  The micro client software connects to the radio end; however, I have a red light on the RTP led and a green light on the com0 led.  I set up the ARCP2000 software at 57600 on com1.  I am using RRC micro client software 1.5.2.  The later versions never gave me a com0 led ever.  The ARCP software lights up momentarily on the connect button and then goes dark.  I tried HRD with the same settings and it too never connects.  Can you please help me as I am unsure what I am doing incorrectly?