1
General discussion forum / Trying to install second RRC Box
« on: 2023-12-10, 18:54:02 »
Can anyone tell me if it's possible to install a second RRC Box at radio side if so how did they do it.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
2
General discussion forum / Yeasu 3000
« on: 2023-10-29, 15:57:30 »
Would anyone know if the Yeasu 3000 is compatible with Remoterig and HRD.
73
73
3
General discussion forum / Pair TWO control boxes to radio
« on: 2023-09-01, 08:56:41 »
Has anyone paired two control boxes to radio side of Kenwood 480. Would like to share remote station with a friend in a different country. If possible would only one be able to control radio.
4
General discussion forum / WIFI Interface Install Problem
« on: 2023-06-16, 02:02:28 »
Hi!
I just purchased a pair of new RRC-1258MkIIs and the WIFI Interface. I have installed these before with no problem on older boxes.
Folled the link and installed it with the setup manager and also within radio control WiFi settings and only working with cable from RRC control to Router.??
For some reason showing in the: Info my Wi-Fi network Ok but will not connect with green light flashing and bleeping. Working without Wifi is OK
73
I just purchased a pair of new RRC-1258MkIIs and the WIFI Interface. I have installed these before with no problem on older boxes.
Folled the link and installed it with the setup manager and also within radio control WiFi settings and only working with cable from RRC control to Router.??
For some reason showing in the: Info my Wi-Fi network Ok but will not connect with green light flashing and bleeping. Working without Wifi is OK
73
5
Allmänt diskussionsforum / Wanted: RemoteRig RRC-1258
« on: 2023-05-16, 22:13:10 »Letar du efter någon som kan ha en uppsättning RemoteRig RRC-1258-enheter till salu? Funderar på att fjärrstyra min Kenwood 480-radio.
PM:a mig med detaljer.
73 Gary
6
General discussion forum / Wanted: RemoteRig RRC-1258
« on: 2023-05-16, 22:11:59 »
Looking for anyone who may have a set of RemoteRig RRC-1258 units for sale? Looking to remote my Kenwood 480 radio.
PM me with details.
73 Gary
PM me with details.
73 Gary
7
General discussion forum / 480 will not connect
« on: 2022-12-01, 04:37:07 »
Can anyone help me out, I have now for the last three day's trying to turn on the Kenwood 480 radio and getting a problems.
Turning on I hear the bleep, face of radio will not light up and a small bleeping from face of radio. Have tried different power supplies and will not light up.
73 Gary
Turning on I hear the bleep, face of radio will not light up and a small bleeping from face of radio. Have tried different power supplies and will not light up.
73 Gary
8
General discussion forum / Kenwood 480 problems
« on: 2022-10-02, 18:29:11 »
Can anyone help me out I can view both radio and control side and looks OK in both the browser for my Kenwood 480 HX.
For some reason over the last few days’ the radio face will not light up and hear a small clicking noise from speaker face.
Have tried changing all cable’s and also second Kenwood SAT face from my car to see if this could be the problem.
Has anyone else had this problem and know how to solve it.
73 Gary
For some reason over the last few days’ the radio face will not light up and hear a small clicking noise from speaker face.
Have tried changing all cable’s and also second Kenwood SAT face from my car to see if this could be the problem.
Has anyone else had this problem and know how to solve it.
73 Gary
9
General discussion forum / Icom 7300 and Remoterig
« on: 2022-10-02, 08:26:09 »
I have been working my Kenwood 480 for many years now with the RRC-1258MkIIs.
Would like to update the radio to my Icom 7300 would this be supported by Remoterig.
Have looked for post's in the Furum and can't see anyone that has got it to work for them.
73S
Would like to update the radio to my Icom 7300 would this be supported by Remoterig.
Have looked for post's in the Furum and can't see anyone that has got it to work for them.
73S
10
General discussion forum / RRC- With Yaesu FTDX3000
« on: 2021-03-29, 21:47:45 »
Can anyone help me out and tell me if possible or have installed both Yaesu FTDX-3000 like the Yaesu FT-450, FT-950, FT-2000, FT-5000 and FT-9000 shown in Yaesu Twin Concept Page.
Both FTDX-3000 are not supported as yet. I have managed to install radio at control side and second FTDX-3000 at the radio side. Looking for the correct cables that I need for radios and control side to work.
Not sure if I have the hardware configuration correct in both wiring of the jumpers installed in each RRC box at the control side and radio side below.
Regards,
Gary
Both FTDX-3000 are not supported as yet. I have managed to install radio at control side and second FTDX-3000 at the radio side. Looking for the correct cables that I need for radios and control side to work.
Not sure if I have the hardware configuration correct in both wiring of the jumpers installed in each RRC box at the control side and radio side below.
Regards,
Gary
11
General discussion forum / Pairing RRC-1258 MKII
« on: 2021-02-28, 13:42:03 »
Hello there can anyone tell me is it possible to pair 2 RRC-1258 MKII control side tougher with radio side. I have pairs of RRC boxes the radio box is 5 miles from me. The control is in my living room plus one in the bedroom.
Can you tell me if let a friend have the second box and his own Kenwood 480 would i be able to share the radio side at the same time when he is located over 400 miles from me and radio.
Kind Regards,
Gary
Can you tell me if let a friend have the second box and his own Kenwood 480 would i be able to share the radio side at the same time when he is located over 400 miles from me and radio.
Kind Regards,
Gary
12
General discussion forum / Yaesu M-1 Base Microphone
« on: 2020-11-10, 13:21:16 »
Hello there can anyone tell me if they would know if the Yaesu M-1 Base Microphone is compatible with RRC-1258MkIIs. have worked both the Yaesu MD-100A8X Yaesu MD-200A8X on the Kenwood 480 Sat with no problem but the M-1 does not key correct when I look at the green on the RRC-1258MkIIs control.
73 Gary
73 Gary
13
General discussion forum / RC-1216H Web-based remote control
« on: 2020-09-27, 02:13:44 »
RC-1216H Remote Control - Unused web-based remote control for ACOM-2000A, Expert Linears, KPA500, SteppIR never unused Pm only please.
Includes
-USB cable,
-Power cable
£180
For more information download the - Users manual
Includes
-USB cable,
-Power cable
£180
For more information download the - Users manual
14
General discussion forum / Acom 2000a install
« on: 2020-08-22, 19:43:46 »
Hi there,
can anyone help me out i installed my Acom 2000a and the mydomain.ddns.webswitch.se example worked OK before i stopped working amp.
Now is showing Dynamic DNS settings correct mydomain.ddns.webswitch.se but for some reason can't be reached and only on the IP address.
Can you tell me can i change the ddns.webswitch.se url username and password be changed in the DNS settings or is there a problem just now.
Many thanks
can anyone help me out i installed my Acom 2000a and the mydomain.ddns.webswitch.se example worked OK before i stopped working amp.
Now is showing Dynamic DNS settings correct mydomain.ddns.webswitch.se but for some reason can't be reached and only on the IP address.
Can you tell me can i change the ddns.webswitch.se url username and password be changed in the DNS settings or is there a problem just now.
Many thanks
15
General / Nano and TS-480
« on: 2020-03-30, 19:58:15 »
Nano and TS-480
Hello there can anyone help me out I bought Remoterig RRC-Nano PRO K over a month ago and set it up correct. The receive is fine working it with my Kenwood 480 SAT and HX.
Getting reports from friends and contacts when I work it that the RRC-Nano PRO, the contacts think that I am on my radio and having problems with the Mic and not the app installed.
I am also looking for any video’s in how you go about installing the RC-1216H Remote control for ACOM 2000A.
Hello there can anyone help me out I bought Remoterig RRC-Nano PRO K over a month ago and set it up correct. The receive is fine working it with my Kenwood 480 SAT and HX.
Getting reports from friends and contacts when I work it that the RRC-Nano PRO, the contacts think that I am on my radio and having problems with the Mic and not the app installed.
I am also looking for any video’s in how you go about installing the RC-1216H Remote control for ACOM 2000A.