Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Jan (Microbit)

Pages: 1 2 [3]
31
Kontrollera att “Debug level” på “Advanced settings”-sidan är satt till “Off” om Webswitchen verkar starta om periodiskt. (“Debug level”-inställningen är borttagen fr.o.m programversion 1.23)

32
If the Webswitch seems to restart periodically, make sure that “Debug level” on the “Advanced settings” page is set to “Off” (“Debug level” is not available in firmware 1.23 and newer.)

34
News / Forum update
« on: 2011-09-22, 13:56:23 »
The forum has been upgraded to the new 2.x version (Which you already most likely have noticed  ;) )

39
Allmänt diskussionsforum / Webswitchens hemsida
« on: 2011-03-07, 15:44:45 »
www.webswitch.se finns det information om Webswitchen.

40
General discussion forum / The Webswitch's home page
« on: 2011-03-07, 15:42:44 »
Visit www.webswitch.se for information about the Webswitch.

41
Some of you have reported problems updating the RRC's firmware using USB. It seems what happens is that you get "Write failed" somewhere in the process of transferring the firmware file to the RRC. This issue is something we are unable to reproduce ourselves, so we would very much like you helping us pinpointing and tracking down what could be the cause of this and hopefully find a way of getting rid of it.

I have created a small program which shows what USB hardware the PC has. If you who have this problem could run it and report your results here we would have more hints as what to do.

It can be found here: http://www.remoterig.com/downloads/MicrobitEnumerator.zip

Just run it and Notepad should launch with a content looking like this:

Microbit USB info v1.0:
USB:[USB Root Hub]
USB:[USB Root Hub]
USB:[Intel(R) 82801G (ICH7 Family) USB Universal Host Controller - 27CB]
USB:[USB Composite Device]
USB:[Intel(R) 82801G (ICH7 Family) USB2 Enhanced Host Controller - 27CC]
Failed getting info(1), error 13!
USB:[USB Serial Converter]
USB:[USB Serial Converter]
USB:[Generic USB Hub]
USB:[Intel(R) 82801G (ICH7 Family) USB Universal Host Controller - 27C8]
USB:[Intel(R) 82801G (ICH7 Family) USB Universal Host Controller - 27C9]
USB:[USB Root Hub]
USB:[USB Root Hub]
USB:[Intel(R) 82801G (ICH7 Family) USB Universal Host Controller - 27CA]
USB:[USB Root Hub]

Add a post to this thread containing that info.

Also, if possible it would be great if you could try putting a High-Speed USB Hub between the PC and the RRC and see if the update works then.

43
Allmänt diskussionsforum / Bara en test!
« on: 2010-12-14, 08:49:28 »
Testar bara att bifoga en fil  ;)

Pages: 1 2 [3]