Topics

1

Feature Requests / Twin FT-DX101

« on: 2019-12-18, 10:46:37 »

The firmware has not been updated for a long time.
Many problems in FT-DX5000 have not been resolved.
Can RRC1278 work with FT-DX101 transceiver in twin mode in future?

Leo RA5A

2

General discussion forum / YAESU twin

« on: 2018-01-29, 17:27:32 »

After a long break, I again began using the equipment remoterig. Сonfiguration equipment FT DX5000 - FT DX 5000. And at the moment I see a few problems:

1. All DSP control does not work. Width, Shift, Cont/APF...
2. I can not change ransmitter power. I do not know what it is, it worked before.
3. If on radio side connected MTU, this function not work in control side.

Is it possible to fix these problems?

3

General discussion forum / Recorder in YAESU TWIN

« on: 2016-04-08, 14:40:25 »

Tooday I testing twin configuration in SSB. Not work FH-2 console in remote. Why?

4

General discussion forum / Problem YAESU twin

« on: 2016-03-30, 14:07:57 »

Hello!

I have som problem with FT DX5000 TWIN. Several time DSP widht not work, power not change.
Also, if I have m-tune preselector units on radio side, I can not use this.
What can I do?

P.S. Firmware 2.90. HW - 7.

5

General discussion forum / i/o port without radio

« on: 2013-06-26, 11:28:03 »

The question in the following.

If I do not use the transceiver whether to run the port and / o?

I need to remotely control a relay. Possibly with feedback.

If this is possible, what settings should I do?

Best regards,
Leo

6

Configuration of Routers, Firewalls, etc / 2 twin radio

« on: 2012-12-19, 15:29:28 »

I tried to put 2 radio in the same subnet.
The first set of twin Yaesu, second Elekraft K3 twin.
Ports in the second RRC (5060, 11000, 12000, 80) changed to others.
Somehow lost control and the voice on the Yaesu twins.
What am I doing wrong?

7

General discussion forum / YAESU TWIN

« on: 2012-05-02, 20:37:06 »

Hello!

I do not work with DSP filters work in the twin. FT DX-5000MP transceivers on both sides. I'm better handle width settings, but nothing happens. Wight changed only roofing filters.
What should I do to be able to control the DSP filters?

8

General discussion forum / Need help with RC1216H.

« on: 2011-12-20, 15:44:23 »

Hello!
A few days ago received a RС1216H switches. Serial numbers 1885,  1886, 1891. I update all devices to version 2.0. After that, look web interface. The situation is as follows. In 1885 and 1891, the title says normal RC-1216H -.
In s/n 1886 title WebSwitch 1216.
Functional are very different.
I need to manage SteppIr antennas and ACOM2000.
How can I fix this problem?

Best regards,
Leo RA5A