Messages

16

Configuration, RRC 1258 / IC 7100 setting of JMP-2 Control RCC

« on: 2016-03-31, 22:19:03 »

I will change from IC706 to IC 7100 and saw in the manual page 23 that for all ICOM radios JMP2 is used

Control-RRC only: JMP-2 is placed near the back of the RRC next to the RESET button. JMP-2
is used to select if the DC-power to the front panels should be 8 or 9 V. With the strap in
place it will be 8V, which fits all ICOM radios. Without the strap the voltage will be 9V, which
fits Kenwood TS-480 and RC-2000 panels that need 9V for the back-lighter.

BUT :
Page 108 shows : NO JMP2 for ICOM IC 7100

Is it ok or a mistake ?

17

General discussion forum / Re: Data Abort

« on: 2016-01-04, 17:07:26 »

Hi Jan...thanks ... will wait for the update....TU , 73, Hans

18

General discussion forum / Re: Data Abort

« on: 2016-01-03, 08:37:11 »

Hi Jan,
tnx fr reply; working with
RRC1258-CRC-v2.87_2015-08-26 ; but it happened alsio from time to time with Version 2.86 before

Got also message Data Abort at 0x0004ae30  called 0x0004ae2c

after hours of stable working......73, Hans

19

General discussion forum / Data Abort

« on: 2016-01-02, 14:26:24 »

Data Abort
0x0004a8a4  called by 0x0004a8a0
It happened from time to time and the connection (IC706) stopped; what does it mean ?

73, Hans

20

Hardware, Cabling, Installations / Re: RF-Protection filter for DSL-Modems

« on: 2013-02-06, 08:36:32 »

Hi Mike and Mitch,
tnx fr quick answer.
fritzbox is equipped with RJ45 at the DSL input; it is very useful because you can take a cat6 cabel for the connection which is much better than the original line cable. A cableoffer from your side would be fine to keep the length as short as possible ! 73, Hans

21

Hardware, Cabling, Installations / RF-Protection filter for DSL-Modems

« on: 2013-02-05, 21:06:52 »

For AVM Fritz!Box I have to use PIN 4 and 5 from RJ45 for the DSL Signal.
Is there a strapping area for configuration inside of the filter box ? 73, Hans

22

General discussion forum / Re: webswitch 1216H malfunktion

« on: 2012-10-04, 12:29:17 »

Thank you for quick replay.....no it is solved and working fine....73, Hans

23

General discussion forum / webswitch 1216H malfunktion

« on: 2012-10-04, 11:15:11 »

Vers. 2.8 was working fine since Sept., 19th as Remote Control for Power Supply and Antenna Selection of the Remote Station of mine.
Since today I have the following malfunktion: After Login I choose "Set Relays" and appox. 2 sec later I was routed to "http://www.webswitch.se/wp/?page_id=477" same happens at all other positions.....always routing to webswitch.se; that makes operating nearly impossible.
I tryed Reset of the Webswitch as well as Reset of the Router (FritzBox) without any success
I am operating via internet; I did not examine the Webswitch in LAN because it is too far away ;-)
Any idea ? TNX Hans, DK3PZ