Author Topic: RRC-1258 mk11 setup  (Read 2352 times)

w6duo

  • Newbie
  • *
  • Posts: 2
    • View Profile
    • Email
RRC-1258 mk11 setup
« on: 2011-10-21, 20:12:08 »
The units were setup and used one year ago and then deactivated. Upon reactivation i reset all units to default. I change the IP's to match my home network IP as noted in the instructions. I am able to get into the units via web interface as mentioned in the instructions. However when i try to get the units to talk to each other i get no activation of the ts-480 and get the blinking yellow light denoting SIP failure.  I also get the alarm tone from the control head.
When i use the default IP's on the units they communicate and i can activate the 480 with all functions operating normally.
What simple step am i missing here.  HELP

Jan (Microbit)

  • Software Developer
  • Administrator
  • Hero Member
  • *****
  • Posts: 1798
    • View Profile
    • Email
Re: RRC-1258 mk11 setup
« Reply #1 on: 2011-10-21, 21:05:06 »
Did you also change "SIP contact" in the control RRC to match the IP of the radio RRC? Which firmware version are you on?
Always include type of hard/software and version when asking for support.

w6duo

  • Newbie
  • *
  • Posts: 2
    • View Profile
    • Email
Re: RRC-1258 mk11 setup
« Reply #2 on: 2011-10-21, 21:42:23 »
Thanks Jan, later on i did read a post regarding setting the sip contact.  I changed that and it worked great. Did i miss that in the instructions?  I spent a few hours trying. So far so good.

thanks
Don