Author Topic: TS-480 + Signaling SL-1+  (Read 1374 times)

sm0mdg

  • Jr. Member
  • **
  • Posts: 36
    • View Profile
TS-480 + Signaling SL-1+
« on: 2012-01-21, 14:40:20 »
I am trying to configure Remoterig so that I can do digital modes using a Signaling SL-1+. I have in addition to the normal TS-480 connections also connected speaker output and tapped Remoterigs 9 volt output to power the interface via the AUX/MIC connector.

It works nice except for one thing, when I connect the headset (with a neil capsule) to do SSB again, the mic is for some reason muted. If I open up the speaker out connection (remove the jumper SPKR > PIN 2) all works normal again.

Did anyone else encountered this problem and found a solution?