Author Topic: any using V2.5 with success?  (Read 2367 times)

Chris DL5NAM

  • Jr. Member
  • **
  • Posts: 63
    • View Profile
    • Email
any using V2.5 with success?
« on: 2012-06-11, 10:46:23 »
Hello, i am using the V2.5 firmware and try to activate in Advanced settings a other function type. Can select a new function type but after Submit and Apply it shows always : Manual relay and temp reading

Also no chance to reach a antennas switch window.

Antenna selection window shows always: Not supported in this Function Type!

Missing a real manual, online help not real a help.

Any comment/help from Remoterig crew is welcome ( Teamviewer still runing :-)


Jan (Microbit)

  • Software Developer
  • Administrator
  • Hero Member
  • *****
  • Posts: 1798
    • View Profile
    • Email
Re: any using V2.5 with success?
« Reply #1 on: 2012-06-11, 12:11:49 »
Hi there,

If you have selected one of these rotators: Prosistel D, Green Heron, DCU1 or Yaesu GS232B then the UART/serial port is already in use and therefore it isn't possible to use other Function types which also use the UART. So what you see is most likely the program blocking combinations of features not supported. That will also make the Antenna selection page show "Not supported in this Function type".

What is a "real manual"? Not paper I suppose, hehe? A PDF maybe?

« Last Edit: 2012-06-11, 12:31:05 by Jan (Microbit) »
Always include type of hard/software and version when asking for support.

Chris DL5NAM

  • Jr. Member
  • **
  • Posts: 63
    • View Profile
    • Email
Re: any using V2.5 with success?
« Reply #2 on: 2012-06-11, 21:56:05 »
Jan, thanks for info.

And YES - a PDF will be fine. Actual online help is not real usefull and a liitle bit "hungry"  ;)


regards
Chris