« previous next »
Pages: [1]

Author Topic: TS-2000 CW problem.  (Read 5990 times)

sv5byr

  • Newbie
  • *
  • Posts: 22
    • View Profile
    • Email
TS-2000 CW problem.
« on: 2013-01-08, 19:45:12 »
Hello and Happy New Year to all,

So far I using my TS-2000 on voice only. Trying to setup the CW operation on remote I realize that my radio is not keying at all...
I have test on remote site the straight key input and works fine with my straight key and also with a homemade COM port keyer (with 4N25). Connecting the key output  from the box to Radio and trying from my Base nothing is happened. I make all combinations on 3,5 mm stereo plug but nothing... I make also all combinations on software but nothing.

 Any Advice pse???
Logged

dj0qn

  • Hero Member
  • *****
  • Posts: 2223
    • View Profile
    • DJ0QN / K7DX
    • Email
Re: TS-2000 CW problem.
« Reply #1 on: 2013-01-08, 19:48:24 »
Did you enable the keyer using with the RRC web config pages? If not, please refer to
page 84 of the manual for details.

73,
Mitch DJ0QN / K7DX
Logged

sv5byr

  • Newbie
  • *
  • Posts: 22
    • View Profile
    • Email
Re: TS-2000 CW problem.
« Reply #2 on: 2013-01-09, 10:47:54 »
Yes all this done....
But nothing
Logged

dj0qn

  • Hero Member
  • *****
  • Posts: 2223
    • View Profile
    • DJ0QN / K7DX
    • Email
Re: TS-2000 CW problem.
« Reply #3 on: 2013-01-09, 10:54:06 »
Send me your keyer and I/O settings for both RRC's, there must be something wrong.

My direct e-mail is dj0qn (at) darc.de.

73,
Mitch DJ0QN / K7DX
Logged

sv5byr

  • Newbie
  • *
  • Posts: 22
    • View Profile
    • Email
Re: TS-2000 CW problem.
« Reply #4 on: 2013-01-09, 22:58:53 »
tnx for response Mitch,
was the I/O on radio side. Now all ok...
Sri for trouble.  Happy New Year.

SV5BYR
Mike
Logged
Pages: [1]
« previous next »