RRC 1258 Support in English > General discussion forum

TS480SAT & SPE 1k-FA

(1/2) > >>

f1tmy:
Hello,

The remoterig interface works very well with ts480sat.
But I have a problem with the control of my spe 1k.

Config is com 1 on the two end (radio & control) with parameter to 5 - 96600/8/1/0 ans 0d.

Then i try to star the control programm the audio switch on-off on-off and so on
The panel switch on-off on-off at the same time.

I think the cable are ok because if the amplifier is on and the to com1 on mode"1" i can control it.

Can anyone help me please?

Best73''

 

e72x:
Hi, I think that you mast cross pins on serial cable on radio side 1258MkII. It means that cross pin.2 with pin. 3. and pin.3 with pin.2. on amplifier side. Please check link
http://www.remoterig.com/schema/Expert-Cable-Ex1.pdf

73,

e72x - Gordan

sm0lyc:
Cross only at one end, otherwise you will have a straight cable again.

/Mikael

f1tmy:
I'll check the cable again but I'm sure they are ok ???
Are you able to start and stop the amplifier with the sofware ?

e72x:
yes, check cable again,I can turn off and on amplifier with software..

Navigation

[0] Message Index

[#] Next page