Webswitch 1216H Support in English > Hardware, Cabling, Installations
Rotator cabeling
(1/1)
OH1MA:
What is connector numbers?
I try to connect Wep switch 1216H to DCU-1 (Idiom press Rotor-EZ) via RS232
I do not have RS-232 Adapter 9PF 1216H, i must make it, but I need diagram of this adapter
2 ----> data out pin?
3 <---- data in pin ?
5 ------ gnd pin?
7 ------ 8
8 ------ 7
sm2o:
http://shop.microbit.se/webshop/catalog/product_info.php?cPath=23&products_id=37
or
http://shop.microbit.se/webshop/catalog/product_info.php?cPath=23&products_id=64
depending on version
/mike
OH1MA:
I think this white 5 pin connector inside Webswitch pins are
1 GND
2 RX
3 TX
4 ?
5 +3.3V
So it need level converter for RS232
Am I right?
Jaakko
sm2o:
Hi
On the page below there is a drawing
/mike
http://www.webswitch.se/wp/?page_id=335
Navigation
[0] Message Index
Go to full version