RRC 1258 Support in English > General discussion forum

TS-480 CAT problems

(1/1)

M0BPQ:
Hi Folks,

I have just picked up a TS-480 to use with my second RRC set of boxes. i have the remote head working FB along with TX/RX audio.

I want to use my Microkeyer II for CAT control and am having problems. The CAT cable from the MKII at the head end works when plugged into the TS-480 directly so this is clearly fine. This leaves me with some  questions:

Which type of cable should I use from the radio RRC com port to the rig? Straight through or null modem?

Also, what settings should I use in the RRC config - I know the baud rate (9K6 in my case), but assume it is 8 bits, 1 stop bit no parity (as per kenwood manual). Should I be using the Forced "0" parity instead?

I assume it doesn't matter which COM port I use?

Thanks!
Steve
M0BPQ


 

Navigation

[0] Message Index