RRC-Nano > General
about frequency step and frequency input ts2000
(1/1)
iw1rdz:
Hi to all, I would like to point two problems with using nano and ts2000.
On nano sw, direct frequency input is limited to 6m while ts2000 goes al least to 70cm band.
Second: over 3g network I would like to have a frequency step of 100Hz, choosable among the others ( the min is 1khz and the auto is not so good over 3g network, while over wifi is ok).
Regards , Steve
Jan (Microbit):
We will have a look at your suggestions 8)
Jan (Microbit):
There will be an update(version 1.2.0) available shortly with the improvements you suggested 8)
Navigation
[0] Message Index
Go to full version