RRC 1258 Support in English > Configuration, RRC 1258

Configuring for JT Modes

<< < (2/2)

k6ufo:
Glad you found the problem. The K3/0-Mini is expecting "microphone" level audio,
and the PC audio card out is at a much higher level. You might have enough
adjustment range in the slider volume controls. A simple in-line volume control
like for headphones, or your own home built voltage divider of 100:1 would help a lot.

W0JM:
Hi! I have the same configuration and am unable to transmit using WSJT remotely. I have good audio out of the Laptop and I see the rig go into transmit mode but no audio. I’ve tried using the 3.5mm jack on the left side of the K3/0 as well as the microphone jack. Any suggestions??? 73- Jeff W0JM

Navigation

[0] Message Index

[*] Previous page