Author Topic: Antenna Selection Page  (Read 1364 times)

Kd5m

  • Newbie
  • *
  • Posts: 2
    • View Profile
Antenna Selection Page
« on: 2015-07-13, 04:02:36 »
I get an error message "Not supported in this Function Type!" when I select the antenna selection page. I have 1216H Webswitch software 4.17 Ham loaded. I do not see the extensive antenna selection page as shown in the help file. Is this my error or a software error?
Thanks for you help.
Edd - KD5M

Jan (Microbit)

  • Software Developer
  • Administrator
  • Hero Member
  • *****
  • Posts: 1796
    • View Profile
    • Email
Re: Antenna Selection Page
« Reply #1 on: 2015-07-13, 08:52:30 »
In order to use Antenna Selection you will have to enable it. That is done on the Advanced Settings page, setting 'Function Type'.
Always include type of hard/software and version when asking for support.

Kd5m

  • Newbie
  • *
  • Posts: 2
    • View Profile
Re: Antenna Selection Page
« Reply #2 on: 2015-07-13, 13:30:19 »
Good morning Jan - thanks for your help. What is the correct "Function Type" to set on the advanced page? I see settings for ICOM, Kenwood, Yaesu, R&S, and some for heating/cooling control. Mine is currently set for "Manual relay and temp reading".
Edd - KD5M

Jan (Microbit)

  • Software Developer
  • Administrator
  • Hero Member
  • *****
  • Posts: 1796
    • View Profile
    • Email
Re: Antenna Selection Page
« Reply #3 on: 2015-07-13, 14:30:08 »
Depends on which radio you have  :)
Always include type of hard/software and version when asking for support.