RRC-Micro PC Client in English > General discussion
RRC-Micro CW macro problem
OH1MLZ:
Setup:
1. RRC-Micro v1.8.0.0
2. Hardware dongle 1274B
3. Operating system Windows 7 Enterprise SP1 64-bit
4. At remote site RRC-1258 MkII with FW version 2.86 and K3 radio
Steps to reproduce the problem:
1. Open RRC-Micro client
2. Set up this CW macro: CFMUR5NN5NNDEOH1MLZTU
3. Other CW settings: speed 35 WPM, delay 50, weight 30
4. Send the macro: it works normally and color coding of sent message turns from yellow to blue in syncronization with sent CW
5. Close RRC-Micro by hitting the red disconnect button but do not close the client
6. Wait for few seconds
7. Push connect to reconnect
8. Send the macro: what happens is that color coding of sent message turns from yellow to blue NOT in syncronization with sent CW, actually much faster AND sent CW message on air is: CFMUR5NN5NNDEO1Z
roland:
Thanks for the report.
Will have a look at that
OH1MLZ:
Good to hear that. Looking forward for the new release. Could you also comment on feasibility of features from my wish list?
Juha
OH1MLZ:
Version 1.9.2.0 tried and it has the same problem.
Jan (Microbit):
--- Quote from: OH1MLZ on 2016-05-31, 08:26:33 ---Version 1.9.2.0 tried and it has the same problem.
--- End quote ---
Radio RRC firmware version?
Navigation
[0] Message Index
[#] Next page
Go to full version