Author Topic: IC 7100 setting of JMP-2 Control RCC  (Read 1324 times)

dk3pz

  • Newbie
  • *
  • Posts: 14
    • View Profile
    • QRZ.COM
    • Email
IC 7100 setting of JMP-2 Control RCC
« on: 2016-03-31, 22:19:03 »
I will change from IC706 to IC 7100 and saw in the manual page 23 that for all ICOM radios JMP2 is used

Control-RRC only: JMP-2 is placed near the back of the RRC next to the RESET button. JMP-2
is used to select if the DC-power to the front panels should be 8 or 9 V. With the strap in
place it will be 8V, which fits all ICOM radios. Without the strap the voltage will be 9V, which
fits Kenwood TS-480 and RC-2000 panels that need 9V for the back-lighter.

BUT :
Page 108 shows : NO JMP2 for ICOM IC 7100

Is it ok or a mistake ?

sm2o

  • Administrator
  • Hero Member
  • *****
  • Posts: 2505
    • View Profile
    • sm2oan
    • Email
Re: IC 7100 setting of JMP-2 Control RCC
« Reply #1 on: 2016-04-01, 09:04:38 »
Hi

Nominal voltage is 8V but everything important regulated so it's not so important.

I will check the manual for discreptances

73 de mike

dk3pz

  • Newbie
  • *
  • Posts: 14
    • View Profile
    • QRZ.COM
    • Email
Re: IC 7100 setting of JMP-2 Control RCC
« Reply #2 on: 2016-04-01, 10:08:51 »
gm Mike,

tnx fr quick reply
....so I have to put in JMP2 to get 8V for the IC7100 and all ( JMP1 - JMP5 ) are in the same configuration as for IC706

73 de Hans, DK3PZ

sm2o

  • Administrator
  • Hero Member
  • *****
  • Posts: 2505
    • View Profile
    • sm2oan
    • Email
Re: IC 7100 setting of JMP-2 Control RCC
« Reply #3 on: 2016-04-01, 10:20:58 »
Hi
Yes that's correct put JMP2 in place

73 de mike