Author Topic: TS-590S TWIN, WITH RRC-1258 MkII  (Read 6069 times)

LA4ESA

  • Jr. Member
  • **
  • Posts: 95
    • View Profile
    • Email
TS-590S TWIN, WITH RRC-1258 MkII
« on: 2017-04-21, 11:31:30 »
I am concidering to by another Kenwood TS-590s, which means i will have one TS-590S at the radio end and one at the control end.
I do have the two boxes, RRC-1258 MkII.
I do also have the cables for running remotely ONE TS-590S.
The question is: can i use the same cables to run TS-590S in the TWIN solution??
The cables i have are called:
1258-K12A13A 75. Kenwood mic adapter cables
1258-CAT-2m  77. CAT cable 2m PC to RRC
1258-CAT-YK  79. Kenwood, Yaesu CAT cable K15c, Y6c. Radio RRC to Kenwood/Yaesu
73 de LA4ESA, Per

sm2o

  • Administrator
  • Hero Member
  • *****
  • Posts: 3004
    • View Profile
    • sm2oan
    • Email
Re: TS-590S TWIN, WITH RRC-1258 MkII
« Reply #1 on: 2017-04-21, 18:10:25 »
Yes the only cable you do not have is the one from the Control-590 CAT-port to the Control-RRC com2

73 de mike

LA4ESA

  • Jr. Member
  • **
  • Posts: 95
    • View Profile
    • Email
Re: TS-590S TWIN, WITH RRC-1258 MkII
« Reply #2 on: 2017-04-24, 11:50:36 »
Thanks for your reply.
Could you please give me article number/name which gives me the possibillity to order from your webshop??

Per
73 de LA4ESA, Per

sm2o

  • Administrator
  • Hero Member
  • *****
  • Posts: 3004
    • View Profile
    • sm2oan
    • Email

LA4ESA

  • Jr. Member
  • **
  • Posts: 95
    • View Profile
    • Email
Re: TS-590S TWIN, WITH RRC-1258 MkII
« Reply #4 on: 2017-04-24, 14:24:17 »
Thanks, cables ordered.
Please comment if i have to change anything in the RRC units, by having a look at the following pasted from the control RRC:

Info on RRC:

Name   Value
Company   Microbit
Product   1258
PID   4
Version   7
HW   8
Software   2.90
Bootloader   1.10
Compiler   4.6.2
Build   Feb 17 2016 10:16:14
ROM/RAM   481192/44080
ETH-RAM   2944 (max 3kB)
USB-RAM   15352 (max 16kB)
Battery-RAM   4
ResetSrc   0 [3]
Last WD Reset   3582799757
Uptime   0 Days, 2 Hours, 59 Mins, 16 Secs
    
Serial number   6289
MAC address   00:1e:fd:01:8f:31
IP address   192.168.0.23
Netmask   255.255.255.0
Gateway   192.168.0.1
DNS   84.208.20.110
Wi-Fi network   not connected
73 de LA4ESA, Per

sm2o

  • Administrator
  • Hero Member
  • *****
  • Posts: 3004
    • View Profile
    • sm2oan
    • Email
Re: TS-590S TWIN, WITH RRC-1258 MkII
« Reply #5 on: 2017-04-24, 14:41:04 »
you need to change programmode to 18. Nothing else if you have set the same baudrate in the new radio as you had in the other one

/micke

LA4ESA

  • Jr. Member
  • **
  • Posts: 95
    • View Profile
    • Email
Re: TS-590S TWIN, WITH RRC-1258 MkII
« Reply #6 on: 2017-04-24, 18:32:48 »
Ok on that, thank you.
Cables are ordered from your webshop.
At the control end, i would like to read SWR etc through HamRadioDeluxe. I suppose i have to connect RRC control unit to my computer through the COM2 port on the RRC and then the COM1 port to the radio at the control end.
But, my computer does not have a RS232 COM port, only lots of USB ports.
Do you have any suggestions of the best RS232/USB cable to use???
Or can i use anyone at the nearest Kjell&co store?? with male RS232 to USB???
73 de LA4ESA, Per

oz1rh

  • Full Member
  • ***
  • Posts: 106
    • View Profile
Re: TS-590S TWIN, WITH RRC-1258 MkII
« Reply #7 on: 2017-04-25, 01:30:52 »
If you are looking for troubles buy a cheap RS232-USB cable with a Prolific chip set inside. Otherwise pay a little more and get a cable with a FTDI chip set.

73, Palle, OZ1RH.

sm2o

  • Administrator
  • Hero Member
  • *****
  • Posts: 3004
    • View Profile
    • sm2oan
    • Email
Re: TS-590S TWIN, WITH RRC-1258 MkII
« Reply #8 on: 2017-04-25, 08:09:56 »
For TS-590 twin, COM2 must be used for the radio-radio control. if you want to connect a PC you do that via com1. You set com1 in Radio-RRC to mode 7. The PC can be connected via USB to com1.

/mike

LA4ESA

  • Jr. Member
  • **
  • Posts: 95
    • View Profile
    • Email
Re: TS-590S TWIN, WITH RRC-1258 MkII
« Reply #9 on: 2017-04-25, 09:40:10 »
Thanks again for quick reply, but do i still need the RS232/USB with the FTDI chip??
So far i have not found the product in any store in Norway.
73 de LA4ESA, Per

sm2o

  • Administrator
  • Hero Member
  • *****
  • Posts: 3004
    • View Profile
    • sm2oan
    • Email
Re: TS-590S TWIN, WITH RRC-1258 MkII
« Reply #10 on: 2017-04-25, 10:02:21 »
No you do not need it you can connect direct with USB

Here is one with FDTI anyway

https://www.electrokit.com/usbrs232-omvandlare-for-pc-mac-linux.49984?gclid=CMjHsPWRv9MCFZfJsgodQwcNEw

/mike

LA4ESA

  • Jr. Member
  • **
  • Posts: 95
    • View Profile
    • Email
Re: TS-590S TWIN, WITH RRC-1258 MkII
« Reply #11 on: 2017-04-25, 10:46:58 »
Thanks again. I look forward to start the project when i receive cables from you and the xtra TS-590 will be picked up on wednesday.
Have a nice day.

Per/LA4ESA
73 de LA4ESA, Per