RRC 1258 Support in English > Configuration, RRC 1258
No access to Control RRC
VE3CFK:
I stupidly set the port number to 79 on the control RRC and now cannot get into the menu of the RRC.
Any suggestions other than a reset of the RRC.
Thanks
73
Chet VE3CFK
dj0qn:
Chet,
As long as you didn't change the IP number, just add the port to the URL seperated
by a colon, e.g. 192.168.1.228:79
73,
Mitch DJ0QN / K7DX
VE3CFK:
Thanks Mitch.
If I enter the ip address, without :79 response I get is "192.168..... refuses to connect".
If I enter the ip address, with:79 response I get is "This site can't be reached. The webpage at...... may temporarily....."
73
Chet VE3CFK
sm2o:
If you connect the USB cable and run the Microbit setup manager you can change the http port under setup (get from device)
/mike
dj0qn:
To add to Mike's comment: you can also click on the button "browse" the RRC and it will load the corect URL in your browser to allow access,
73,
Mitch DJ0QN /K7DX
Navigation
[0] Message Index
[#] Next page
Go to full version