RRC-Micro PC Client in English > General discussion
PC micro com port 1
(1/1)
KD0PO:
I have a green hereon rotor controller attached to the radio RRC.
When using the control RRC I had it as the port 1 set to mode 3, character time out.
How can I set the virtual comport 1 in the PC micro to control com pot 1 on the radio RRC for my rotor???
thank you for an excellent product
Ray
KD0PO:
anyone have any ideas???
sm2o:
Hi
why shouldn't it work ? You set up a com port in the RRC-micro in the same way as you do for the radio control. it's no difference. RCC-Micro can transfer 3 com ports.
73 de mike
KD0PO:
--- Quote from: sm2o on 2018-01-16, 08:46:32 ---Hi
why shouldn't it work ? You set up a com port in the RRC-micro in the same way as you do for the radio control. it's no difference. RCC-Micro can transfer 3 com ports.
73 de mike
--- End quote ---
Mike, that's great. I agree it should work.
Can you give me the settings to use both for the PC Micro and the radio RRC
box to make it all work with a green herron rotor control???
as I stated above when I use the RRC control to the radio RRC I used mode 3, charactor time out
and everything works as it should..
Mode 3 charactor time out is NOT available as a PC Micro setting.
So which setting should I choose to get it all working??
Thank you for a great product and support.
best 73, Ray
sm2o:
Hi
I no expert of Green Heron. Mode 1 is the safest to test with, as characters are sent one by one. It's always a risk that the control program is not working well with virtual serial ports, but normally they do. If you don't make it our webswitch 1216 may be a solution http://www.remoterig.com/wp/?page_id=166
73 de mike
Navigation
[0] Message Index
Go to full version